If you need a roof to extend from the house to an outbuilding for some reason but without supports down its length connect.
Move walls attached to roof sims 3.
The workaround is to place them then use sims 3 cam and zoom in close in cutaway.
Start with the walls of your barn then go up a level and add another set of walls but make this set one space in along the sides.
Just add a piece of wall or a column where each corner will be and you should then be able to place the roof.
You must work with the wall to find that height again.
Add a little trim work and your done.
I m not terribly concerned about it.
That above is the problem i m having.
The other problem is a message that says can t intersect other objects this one is because something is getting in the way.
Now lower the roof.
Its a pain has no design sense at all and generally just looks lousy.
Using the half gable tool place a roof along the thin outer edge of the second floor on both sides and a gable roof on the top section.
Once you move the terrain under a guide wall the walls above it will again go back to normal height.
Grab the diagonal half hipped roof and rotate it so the flat side is facing the front of the room.
Just thought it was something that should be mentioned to the engineers.
Putting all the walls down allows you to place wall hangings but then you can t move them.
I don t have any coielings but i have already tried replacing them and the two roofs either side above the bay windows don t go through either even though those rooms don t have a ceiling.
The only thing is the front wall has to be an even number of blocks wide for it to work.
The sims 3 wall curving beginner and intermediate tutorial by nore negonc.
Once the roof is in place you can remove the support.
Here s one with the front wall four blocks wide and the roof raised up some.
Like this now just move into place on the right side.
You can notice here that i had to lower the height to get.
As you can see over the open reception area the roof is coming through.