My Garage Door Does Not Close All The Way

The travel controls how far the door goes up and down.

My garage door does not close all the way.

Garage door sensors may not be aligned correctly 3. First you need to see what has caused this to happen. But when your garage door opener fails to close completely if you don t figure out the problem you ll soon be back to the old fashioned way of opening and closing the garage door. Garage door seal may be damaged 4.

To check the balance pull the emergency release cord or chain to disconnect the door. Though this problem should be obvious it shouldn t be overlooked. From here lift the garage door by hand about 3 feet above the ground and then release the door and see were it lands. Depending on the brand.

If one of them is off or blinking it means the invisible beam that tells the opener that the way is clear for the door to close isn t aligned. If your garage door is not balanced right it won t go up or down all the way. You just need to adjust the travel setting on your door opener. First check the sensor lights.

Something blocking the door. There are of course many other problems that can keep your garage door from functioning properly. Garage door opener malfunction or door has shifted. You can usually realign it by loosening a knob or.

Check to see if there are new cracks in the garage floor. Since you live in an area with cold weather the garage floor may have shifted slightly therefore making the door not shut all the way. If one side of the door is not in line with the other the door won t run smoothly in its tracks and when closed one side of the door won t close completely leaving an open gap. You should now be able to move the door up and down by hand.

One or more of these reasons is likely responsible for your garage door closing partially but not all the way. Bottom of the door is up on one side. One of the more difficult problems for do it yourselfers to diagnose is a worn cable pulley on an extension spring door. The door won t close all the way if the bolt is too high on the track.

Click on a problem below to see the possible causes and solutions. Genie openers apply only limited force to the garage door during closing. If there s something blocking the door from closing all the way a full close will be impossible. Side mounted extension springs are installed above the horizontal roller tracks on both sides of the door.

Step 4 turn the close force dial in small increments until the garage door reaches the ground when you hit the close button on the remote.