Nailing Chedule For Cedar Siding

Do not reduce the siding overlap recommendations given in the installation sections of this publication.

Nailing chedule for cedar siding.

These nails offer a small head design and a ring shank for pull out resistance. For siding used as soffit material the siding must be nailed 12 in. For siding up to 6 inches wide use one nail one inch up from the lap. I am finally finishing the residing of the back side of my house.

Take care not to nail through the overlap of two pieces. Use this grip rite 1 3 4 in. Fasten from end to end or center to end to avoid internal stress. Rigid foam sheathing as a nailing base for cedar siding is not recommended.

Allow a 1 8 inch expansion gap between pieces if the siding is air or kiln dried. 5d galvanized shake nails 1 lb pack for cedar shake applications. Fasten the plank with galvanized ring shank nails long enough to penetrate the siding sheathing and into the wall studs at least 1 1 4 inch. 5d galvanized shake use this grip rite 1 3 4 in.

Drive nails through the bottom of the board about 1. It originally had cedar lap siding and then they applied cedar shake shingles over that. Place nail just above the overlap. Bevel siding should be face nailed to studs with 1 1 4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center.

When installing vertical siding over stud walls horizontal blockers are needed and should be spaced not exceeding 24 inch on center. The footnote to table 3 gives nail length recommendations for siding. For best results with rigid foam and other sheathing products follow the nailing recommen dations given in this publication as to nail type positioning penetration and spacing. I removed all the shingles and am going to put beveled cedar 1x8 siding over the original siding i already did this on other parts of the.

Do not nail through overlaps. More product details close.